Stress-wave propagation across material interfaces in multimaterial metallic specimens produced by laser powder bed fusion

Authors

DOI:

https://doi.org/10.21014/actaimeko.v15i4.2512

Keywords:

Hopkinson bar, metallic multimaterial, stress-wave propagation, strain gauge

Abstract

The propagation of short broadband stress waves across a material interface in additively manufactured multimaterial specimens was experimentally investigated. Cylindrical CuCr1Zr--13Ni400 specimens produced by laser powder bed fusion were tested using a Forward Direct Impact Hopkinson Bar with a striker length of  5 mm. Strain gauges were positioned immediately before and after the internal material interface, allowing the wave response to be examined locally in both propagation directions. Geometrically identical single-material specimens were used as references. The experiments were performed in the elastic regime, enabling repeated impacts on the same specimens. The material interface produced measurable changes in the temporal shape of the stress pulse, with deviations from the homogeneous reference occurring at times consistent with the expected arrival of reflected wave components. The response depended on the direction of wave propagation across the interface. The FFT analysis also revealed changes in the relative frequency content, particularly at the measurement position before the interface. Similar reductions in stress and spectral amplitude were observed during propagation in both homogeneous and multimaterial specimens, demonstrating the significant influence of propagation and dispersion in the finite cylindrical geometry. The results show that the measured response results from the combined effects of interface interaction, broadband excitation, and dispersive wave propagation.

Downloads

Published

2026-11-20

Issue

Section

Research Papers