Full-field characterization of strain localization and damage evolution in additively manufactured continuous carbon fiber-reinforced polyamide 6 under compression

Authors

DOI:

https://doi.org/10.21014/actaimeko.v15i4.2493

Keywords:

additive manufacturing, continuous carbon fiber-reinforced composites, compression testing, digital image correlation, X-ray computed tomography, damage evolution

Abstract

This paper investigates the compressive behavior of additively manufactured polyamide 6 composites reinforced with continuous carbon fibers and loaded along the fiber direction. Unidirectionally reinforced specimens were manufactured by continuous fiber co-extrusion and subjected to monotonic and cyclic compression in accordance with ASTM D695. Prior to mechanical testing, X-ray computed tomography was used to assess manufacturing-induced porosity, while digital image correlation provided full-field kinematic measurements throughout loading.

Both specimens reached an ultimate compressive stress of approximately 99 MPa, with measured porosity levels ranging from 11 to 14 %. Under monotonic loading, strain progressively localized with increasing load, while post-failure observations revealed local crushing, fiber kinking, longitudinal splitting, and interlaminar delamination. Cyclic loading resulted in pronounced hysteresis, accumulation of irreversible strain, and progressive stiffness degradation. The digital image correlation fields captured the evolution and localization of longitudinal and transverse strains, while the correlation residuals provided complementary information on local surface changes associated with damage. The results demonstrate the capability of full-field digital image correlation measurements to characterize strain localization and damage evolution in additively manufactured continuous carbon fiber-reinforced polyamide 6 composites under compressive loading.

Downloads

Published

2026-11-19

Issue

Section

Research Papers