Impact of contact force on the ultrasonic signal amplitude in carbon steel: A systematic evaluation

Authors

  • Alex Teixeira Inmetro
  • E. William Santos Laboratory of Ultrasound (LABUS), Directory of Scientific and Industrial Metrology (DIMCI), National Institute of Metrology, Quality, and Technology (INMETRO), Duque de Caxias – RJ, Brazil
  • T. C. Dourado Laboratory of Ultrasound (LABUS), Directory of Scientific and Industrial Metrology (DIMCI), National Institute of Metrology, Quality, and Technology (INMETRO), Duque de Caxias – RJ, Brazil
  • S. A. Miqueletti Laboratory of Ultrasound (LABUS), Directory of Scientific and Industrial Metrology (DIMCI), National Institute of Metrology, Quality, and Technology (INMETRO), Duque de Caxias – RJ, Brazil
  • R. P. B. Costa-Félix Laboratory of Ultrasound (LABUS), Directory of Scientific and Industrial Metrology (DIMCI), National Institute of Metrology, Quality, and Technology (INMETRO), Duque de Caxias – RJ, Brazil

DOI:

https://doi.org/10.21014/actaimeko.v15i1.2021

Keywords:

ultrasound, transducer contact force, signal amplitude, carbon steel, non-destructive testing, Industry 4.0

Abstract

Ultrasonic testing is widely used in industrial non-destructive evaluation; however, the influence of transducer contact force on signal stability during conventional contact measurements is still insufficiently documented for metallic specimens. This study investigates the effect of applied contact force on ultrasonic wave velocity and signal amplitude in SAE 1020 carbon steel, using a 5 MHz contact transducer and a controlled loading device. Three cylindrical specimens were tested under increasing, decreasing, and cyclic force protocols within a range of 2 to 20 kgf. The results showed negligible variation in ultrasonic velocity throughout the investigated force range, whereas signal amplitude increased markedly at low forces and reached a plateau near 10 kgf. These findings indicate that contact force primarily affects coupling efficiency and signal amplitude, rather than bulk wave velocity, under the present experimental conditions. The proposed procedure contributes to improved repeatability and supports more reliable contact-based ultrasonic measurements in industrial practice.

Downloads

Published

2026-03-26

Issue

Vol. 15 No. 1 (2026)

Section

Research Papers

License

Copyright (c) 2026 Alex Teixeira, E. William Santos, T. C. Dourado, S. A. Miqueletti, R. P. B. Costa-Félix

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under the CC BY 4.0, Creative Commons Attribution 4.0 International License.

Users are free to

  • share, i.e. copy and redistribute the material in any medium or format for any purpose, even commercially;
  • adapt, i.e. remix, transform, and build upon the material for any purpose, even commercially.

At the same time, the user must give appropriate credit, provide a link to the license, and indicate if changes were made.
Additional information about the license can be found at: https://creativecommons.org/licenses/by/4.0/.

Authors are

  • able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
  • permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).